The Copy Sheet dialog allows you to create a new sheet in the design by copying a specified sheet. It is launched by right-clicking a circuit, definition block or sheet in the Design Tree panel, and selecting Copy Sheet on the assist menu. Alternatively, click a circuit, definition block or sheet in the Design Tree panel, and type Ctrl + C. The Copy Sheet dialog is displayed when you type Ctrl + V to paste the copied sheet.
Note
- You cannot copy an open sheet.
- Copied sheets are not automatically checked for duplicate reference designator values.
- To reorder, rename or delete multiple sheets, launch the Sheet Reorder dialog from the Design Tree panel, when the relevant sheets are closed.
Dialog
| Value | Description | |
|---|---|---|
| Source | Displays the location of the sheet that is copied. If the dialog is launched from a circuit or definition block in the Design Tree panel, then specify the schematic folder or block that contains the sheet, and the sheet number. | |
| Circuit/Block |
|
|
| Sheet |
Note
You must first select a value in the Circuit/Block box before any values are listed. |
|
| Destination | Specify the destination to which the sheet is copied. | |
| Circuit/Block |
Note
You cannot specify a destination by selecting it in this box. |
|
| Sheet Number | Specify the number of the new sheet. By default, it is set to the highest existing sheet number + 1. If the maximum sheet number is already used, then this value is set to the first non-existent sheet number below this. | |
| OK | Copies the specified sheet, and closes the Copy Sheet dialog. The design is saved automatically. | |
| Cancel | Closes the Copy Sheet dialog without copying a sheet. |
