The Rotate command allows you to rotate an object on the canvas in eCADSTAR PCB Editor. Launch this command by clicking Home > Move > Rotate on the ribbon.
Command dialog
Rotation angle
| Value | Description |
|---|---|
| Real number greater than -360, and smaller than 360. | Specify the rotation angle. The value that you specify is displayed
in the command dialog when you next run the following commands
in eCADSTAR PCB Editor: Rotate Move Duplicate (Move) Duplicate (Rotate) Paste Align Component Rotate Around Reference Point Rotate by Specified Angle |
Conductor
This section allows you to specify whether net information is kept when an object is moved.
Keep net
| Value | Description |
|---|---|
| ON | If selected, all net information is kept when the object is moved. |
| OFF | If selected, no net information is kept when the object is moved. |
Component
This section allows you to specify whether components are also moved that are in the same placement group as the relevant object.
Move entire placement group
| Value | Description |
|---|---|
| ON | If selected, components are also moved that are in the same placement group as the relevant object. |
| OFF | Only the relevant object is moved. |
