Cross Reference

For non-hierarchical designs, the Cross Reference dialog allows you to define the default format of the labels that show the connected sheets for a sheet connector. These are displayed on the canvas in the Property Viewer, illustrated below.

Launch this dialog by clicking Sheet > Label > Cross Reference on the ribbon in eCADSTAR Schematic Editor. You must execute the Cross Reference command to display this Property Viewer for a newly-added sheet connector.

 

 

Value		Description
Item Separator		If a sheet connector links to multiple sheets, then the character that you specify is displayed between each linked sheet in the Property Viewer on the canvas. It is also displayed in the XY location label field in the Properties Panel. Specify a single alphanumeric character.
Field Separator		Allows you to specify the character that is displayed between the sheet number and the zone value in the Property Viewer. It is also displayed in the XY location label field in the Properties Panel. Specify a single alphanumeric character. Note Zones define areas of a sheet, based on their X and Y location. The specified character cannot be the same as the Item Separator character.
Suppress leading zeros in Sheet Number		Allows you to specify whether any leading zeros in the sheet number are displayed on the schematic and in the Property Viewer and the XY location label field in the Properties Panel.
	Selected	Leading zeros in the sheet number are not displayed on the schematic and in the Property Viewer or the XY location label field in the Properties Panel.
	Not selected	Leading zeros in the sheet number are displayed on the schematic and in the Property Viewer and the XY location label field in the Properties Panel.