The Move Origin, Change Sheet Size and Change Symbol Size commands allow you to move the origin of a sheet, and change the size of designs in eCADSTAR Schematic Editor and Symbol Editor. Each command is described below.
Move Origin
The Move Origin command allows you to change the origin of a sheet in eCADSTAR Schematic Editor or Symbol Editor. Execute this command as follows.
- In eCADSTAR Schematic Editor ribbon, click Sheet > Setting > Move Origin on the ribbon.
- In Symbol Editor ribbon, click Home > Setting > Move Origin or Design > Setting > Move Origin on the ribbon.
Define the position of the new origin by clicking on the canvas.
Assist Menu
Change Sheet Size
The Change Sheet Size command allows you to change the size of the displayed sheet in eCADSTAR Schematic Editor. It is executed by clicking Sheet > Setting > Change Sheet Size on the eCADSTAR Schematic Editor. On the canvas, click two positions to define the opposite corners of the sheet. The sheet is changed to the size that you specify.
Assist Menu
Change Symbol Size
The Change Symbol Size command allows you to change the size of the sheet that is associated with the displayed symbol in Symbol Editor. It is executed by clicking Home > Setting > Change Symbol Size or Design > Setting > Change Symbol Size on the Symbol Editor ribbon. On the canvas, click two positions to define the opposite corners of the sheet. The sheet is changed to the size that you specify.
Assist Menu
