The Line (Circle) command allows you to input a circle in Footprint Editor by specifying the center point, and a point on the circumference. It is only available in 2D View mode.
Command Dialog
Line width
| Value | Description |
|---|---|
| A real number greater than 0. | Set the width of the generated line. Specify a real number greater than 0. |
Line type
| Value | Description | |
|---|---|---|
| Line type | Specify the format of the line. | |
| Solid | A solid line is generated. | |
| Dash | A dashed line is generated. | |
| Dash dot | A "dash-dot" line is generated. | |
| Dash dot dot | A "dash-dot-dot" line is generated. |
