Line (Polyline)

The Line (Polyline) command in Footprint Editor allows you to create a line by specifying vertices. It is executed by clicking Home > Shapes> Polyline on the Footprint Editor ribbon. It is only available in 2D View mode.

Command Dialog

Angle lock

Value	Description
45-degree	The angle (in degrees) between the sides of the figure to be input is limited to the following values. 0 45 90 135 180 225 270 315
90-degree	The angle between the lines, or between the sides of the area to be input, is limited to the following values (in degrees) 0 90 180 270
Free	The angle between the sides of the figure to be input is not locked.

Line width

Value	Description
A real number greater than 0.	Set the width of the generated line. Specify a real number greater than 0.

Tangent arc

Value	Description
ON	A tangent arc with the radius that is specified in the Radius of tangent arc field is generated at the corner of a figure.
OFF	The vertex is placed at the corner of a figure.

Radius of tangent arc

Value	Description
Real number greater than 0.	Set the radius of the tangent arc to be generated.

Line type

Specify the format of the line.

Value	Description
Solid	A solid line is generated.
Dash	A dash line is generated.
Dash dot	A dash-dot line is generated.
Dash dot dot	A dash-dot-dot line is generated.