Section Settings
The Section Settings dialog allows you to specify the items that are output for the mode that you select in the Output (IPC-2581) Dialog. This dialog can be launched only when the IPC-2581C format is selected, and a mode other than All or BOM is selected in the Mode box.
The following table shows the sections that can be specified for the relevant modes in the Output (IPC-2581) Dialog.
Y = The section is output for the relevant mode.
N = The section is output for the relevant mode.
O = Select the check box to specify the relevant section.
| Section | Key | All | BOM | Stackup | Fabrication | Assembly | Test | Stencil | Userdef |
|---|---|---|---|---|---|---|---|---|---|
| BOM & AVL | B | Y | Y | O | O | Y | Y | N | O |
| Component Packages | C | Y | N | N | N | Y | Y | O | O |
| Component Assembly | A | Y | N | N | N | Y | Y | N | O |
| Stackup | S | Y | N | Y | Y | N | N | N | O |
| Profile (Outline) | U | Y | N | 0 | Y | Y | Y | Y | O |
| Solder Mask Layers | M | Y | N | N | Y | N | N | O | O |
| Solder Paste Layers | P | Y | N | N | N | O | N | Y | O |
| Silkscreen (Legend) Layers | L | Y | N | N | Y | Y | Y | O | O |
| Drill and Routing Layers | R | Y | N | O | Y | Y | Y | O | O |
| Documentation Layers | D | Y | N | O | O | O | O | O | O |
| Outer Copper Layers | O | Y | N | Y | Y | Y | Y | O | O |
| Inner Copper Layers | I | Y | N | Y | Y | N | N | N | O |
| Dielectric Layers | E | Y | N | 0 | O | N | N | N | O |
| Logical Netlist | G | Y | N | N | O | O | O | N | O |
| Physical Netlist | Y | Y | N | N | Y | O | Y | N | O |
