For the routing that is performed by the Autoroute command, the Accept Autorouting dialog allows you to view, and apply the changes to the current design. It is displayed automatically after you execute a routing strategy in the Routing Strategy dialog. You can also launch it by clicking Net / Route > Autorouting > Accept Autorouting on the ribbon.
Command dialog
| Value | Description |
|---|---|
| Result | Displays the results of the routing that is performed by the Autorouter command. If you select a task in this box, then the results that are associated with it are displayed on the eCADSTAR PCB Editor canvas. If you click Final result, then the results that are associated with all the tasks are displayed. |
| Apply | For the tasks that you select in the Result box, clicking Apply updates the design with the associated results. If you click Final result and click Apply, then the results associated with all the tasks are applied to the design. Any pourable copper templates are refilled with copper around the new routing. The Accept Autorouting dialog is closed. |
| Exit | Closes the Accept Autorouting dialog without updating the design with the results of the routing strategy. If necessary, you can apply these results at a later time, as follows: select the routing area, and then click Net / Route > Autorouting > Accept Autorouting. Alternatively, right-click the routing area and select Accept Autorouting on the context menu. |
Note
- You may be able to make routes more visible
by toggling the display of unrouted nets. This is done by clicking
Net / Route > Net >
Display Nets on the eCADSTAR PCB Editor
ribbon. Alternatively, clickDisplay
Nets on the Quick Access Toolbar. - When this dialog is displayed, any links in Autoroute report dialogs are disabled. To enable these links, close this dialog and then relaunch it when required by clicking Net / Route > Autorouting > Accept Autorouting on the ribbon. To accept the autorouting result, re-select the routing area or the whole board on the canvas.
