Line (Rectangle)
The Line (Rectangle)
command allows you to create a rectangle using lines(only
available in 2D View mode). Launch this
command by clicking on the ribbon in eCADSTAR PCB Editor.
Command dialog
Line (Conductor)
Track width
| Value |
Description |
| Real number greater than 0. |
Set the width of the generated track. |
Tangent arc
| Value |
Description |
| ON
|
A tangent arc with the radius that is specified in Radius
of tangent arc is generated at the corner of the track. |
| OFF
|
A vertex is placed at the corner of the track. |
Radius of tangent arc
| Value |
Description |
| Real number greater than 0. |
Set the radius of tangent arcs that are generated when Tangent arc is set to ON. |
Line (Non-Conductor and Drawing)
Line width
| Value |
Description |
| Real number greater than 0. |
Set the width of the generated line. |
Tangent arc
| Value |
Description |
| ON
|
A tangent arc with the radius that is specified in Radius
of tangent arc is generated at the corner of the line. |
| OFF
|
A vertex is placed at the corner of the line. |
Radius of tangent arc
| Value |
Description |
| Real number greater than 0. |
Set the radius of tangent arcs that are generated when Tangent arc is set to ON. |
Line Type
| Value |
Description |
| Solid
|
A solid line is generated. |
| Dash
|
A dash line is generated. |
| Dash dot
|
A dash-dot line is generated. |
| Dash dot dot
|
A dash-dot-dot line is generated. |
Rectangle on the ribbon in eCADSTAR PCB Editor.