The Board Block command
allows you to create an area to divide the board. This is done by specifying
the vertices of a polygon on the canvas. The command is launched by clicking
Board Block > Board Block > 
Board Block (Polygon)
on the eCADSTAR PCB Editor
ribbon. The Board Block (Polygon) dialog
is displayed. This dialog allows you to specify the angle lock for the
sides of the figure. Once you have created a polygon board block, the
Save As dialog is displayed.
Command dialog
Angle lock
| Value | Description |
|---|---|
| 45-degree | The angle between the sides of the figure to be input is limited to 0, 45, 90, 135, 180, 225, 270, and 315 degrees. |
| 90-degree | The angle between the lines to be input is limited to 0, 90, 180 and 270 degrees. |
| Free | The angle between the sides of the figure to be input is not locked. |
