Slot Hole
Use the Slot Hole
command to create a slot hole in the board (only available in 2D
View mode). Launch this command by clicking on the ribbon in eCADSTAR PCB Editor.
Command dialog
Hole diameter
| Value |
Description |
| Real number greater than 0. |
Set the diameter of the slot hole that is added. This must
be smaller than or equal to Length. |
Length
| Value | Description |
| Real number greater than 0. | Set the length of the slot hole that is added. This must be
greater than or equal to Hole diameter. |
Angle
| Value | Description |
| Real number greater than -360 and smaller than 360. | Set the angle of the hole that is added. |
Slot on the ribbon in eCADSTAR PCB Editor.