Electrical Editor: Copying and Pasting Objects

The following procedure describes how to copy a selected object to the clipboard, and then paste it to the canvas in Electrical Editor.

1. With an object selected, press Ctrl+C. Alternatively, click Copy on the assist menu. The object is copied and stored in the clipboard. To cut an object, press Ctrl+V with the object selected. Alternatively, click Cut on the assist menu.

2. If you press Ctrl+V, the object that is stored in the clipboard is put into the state of being dragged. Alternatively, click Paste on the assist menu.

Target objects

• Driver pin
• Receiver pin
• Tri-state driver pin
• Bidirectional pin
• Differential driver pins
• Differential receiver pins
• Tri-state differential driver pins
  
• Differential bidirectional pins
• Connector
• N-port
• Resistor
• Inductor
• Capacitor
• Via
• Complex via
• Power/GND
• Connection
• Transmission line
• Differential line