Chamfer Route

The Chamfer Route command allows you to chamfer the corners of a selected track. It is executed by clicking Net / Route > Routing > Chamfer Route on the eCADSTAR PCB Editor ribbon.

Command dialog

Maximum cut

Value	Description
Real number greater than 0.	For the vertex to be chamfered, specify the distance from the vertex to the start of the chamfer.

Minimum cut

Value	Description
Real number equal to or greater than 0.	If the distance from the vertex to be chamfered is equal to, or smaller than the specified value, then the Chamfer command is not executed.

Thermal relief

Value		Description
ON		In the same net as the area to be generated: the subtract process is executed on pins, vias and padstacks in components. This generates thermal lines.
OFF		In the same net as the area to be generated: the subtract process is not executed on pins, vias or padstacks in components.
	Settings	Displays the Design Settings dialog. This dialog allows you to set the thermal relief values which are shared between multiple commands.

Subtract parameter

Value	Description
Defaults	Displays the Design Settings dialog. This dialog allows you to set the Subtract parameter values which are shared between multiple commands.

 

Value	Description
Apply	The corners of the selected track are chamfered. The Chamfer Route dialog remains open.
Exit	Closes the Chamfer Route dialog without chamfering the corners of a track.