Fillet

The Fillet command allows you to fillet the corners of an object (only available in 2D View mode). This command is executed by clicking Shape > Reshape > Fillet on the eCADSTAR PCB Editor ribbon.

Command dialog

Maximum radius

Value	Description
Real number greater than 0.	The maximum radius of the tangent arc that is used to create the fillet. The selected corner is filleted using the largest possible value, up to the Maximum radius value. This value must be greater than the Minimum radius value.

Minimum radius

Value	Description
Real number equal to or greater than 0.	The minimum radius of the tangent arc that is used to create the fillet. This value must be less than the Maximum radius value.

Thermal relief

Value		Description
ON		In the same net as the area to be generated, the subtract process is executed on pins, vias and padstacks in components. This generates thermal lines.
OFF		In the same net as the area to be generated, the subtract process is not executed on pins, vias or padstacks in components.
	Settings	Displays the Design Settings dialog. This dialog allows you to set the thermal relief values which are shared between multiple commands.

Subtract parameter

Value	Description
Settings	Displays the Design Settings dialog. This dialog allows you to set the Subtract parameter values which are shared between multiple commands.

 

Value	Description
Apply	The corners of the object that you select on the canvas are filleted using the values specified in the Fillet dialog. The Fillet dialog remains open.
Exit	Closes the Fillet dialog without filleting the corners of the selected object.