The Angle Dimension (Angle) command, in eCADSTAR PCB Editor, allows you to input angle dimensions to the drawing layer of the active layer. You can change the properties of the dimension by selecting it on the canvas, and then editing the settings in the Properties panel. To change the dimension value and the position of the dimension, set Edit dimension to ON and then drag it on the canvas. This command is only available in 2D View mode.
View dimension lines on the canvas as follows.
- In the Layer
Settings panel, select
Visible
drawing layer in the Drawing layer
section. To display this column in the Layer
View table, select Show in grid
in the Drawing layer section. - For the relevant layer in the Layer
Settings panel, Layer name column,
select theVisible drawing layer check box.
Command dialog
Arrow direction
| Value | Description |
|---|---|
| Inward | The arrow is oriented inward. |
| Outward | The arrow is oriented outward. |
Aux line at start point
| Value | Description |
|---|---|
| ON | An auxiliary line is displayed on the start point side. |
| OFF | No auxiliary line is displayed on the start point side. |
Aux line at end point
| Value | Description |
|---|---|
| ON | An auxiliary line is displayed on the end point side. |
| OFF | No auxiliary line is displayed on the end point side. |
Arrow type
| Value | Description |
|---|---|
| No arrow | The arrow type at the start point is set to no arrow. |
| Circular arrow | The arrow type at the start point is set to circular. |
| Closed arrow | The arrow type at the start point is set to closed. |
| Open arrow | The arrow type at the start point is set to open. |
Dimension text attributes
| Value | Description |
|---|---|
| Settings | Specify the attributes for dimension text in the Design
Settings dialog. By default,
drawing layers are set to No Width
in the Layer
Settings panel. In order to change the width of lines used
for dimension text, this setting must be changed to Width,
as follows:
|
View drawing styleTolerance text
| Value | Description |
|---|---|
| ON |
Positive and negative manufacturing tolerances are displayed on the canvas for dimensions that you add using a dimension command. This is illustrated in the following example.
The Positive Tolerance and Negative Tolerance fields are made available. The values that you specify in these fields are displayed in the relevant dialog for every dimension command. |
| OFF | Tolerances are not displayed on the canvas for dimensions. The Positive Tolerance and Negative Tolerance fields are made unavailable. |
If you change the units in a design, the tolerances that you specify are not changed.
Positive Tolerance
| Value | Description |
|---|---|
| Real number greater than or equal to 0. | Specify the positive tolerance for all dimensions that you add using a dimension command. The value that you specify is displayed on the canvas, with a "+" prefix. It is displayed after the dimension value. |
Negative Tolerance
| Value | Description |
|---|---|
| Real number greater than or equal to 0. | Specify the negative tolerance for all dimensions. The value that you specify is displayed on the canvas, with a "-" prefix. It is displayed after the dimension value. |
Edit dimension
| Value | Description |
|---|---|
| ON | Allows you to change the dimension value and the position of any dimension that you select on the canvas. |
| OFF | You cannot edit dimensions that you select on the canvas. |
