The Initial Condition dialog allows you to set the initial conditions and nodes for simulation. These are output as the .IC and .NODESET statements of the simulator. You can select nodes and nets, and enter a value. To make this dialog available, select Options in the Analysis Conditions dialog. Launch it by double-clicking Initial Condition in the SPICE Controller Manager, Analysis Tree, or by right-clicking it and selecting Open.
Notes
Values that you specify in this dialog must not contain spaces.
Values that you specify in this dialog must not contain spaces.
| Item | Description | |
|---|---|---|
| .IC tab | Allows you to specify a voltage value for the corresponding signal. These are output as the .IC statements of a simulator. | |
| Node name | Allows you to specify a signal by selecting the corresponding check box. | |
| Value | Specify a voltage value for the corresponding signal. | |
| .NODESET tab | Allows you to specify a voltage value for the corresponding signal. These are output as the .NODESET statements of a simulator. | |
| Node name | Allows you to specify a signal by selecting the corresponding check box. | |
| Value | Specify a voltage value for the corresponding signal. | |
| OK | Saves the specified settings and closes the Initial Condition dialog. | |
| Cancel | Closes the Initial Condition dialog without saving any unsaved changes. | |
| Apply | Saves the specified settings to the SPICE Controller Manager. The Initial Condition dialog remains open. |
