Testpoints Dialog

The Testpoints dialog displays the values associated with testpoints, including their error status, if applicable. It is displayed by clicking Net / Route> Testpoint > Testpoint split menu > Display Testpoint Table on the ribbon.

Item		Description
Show only testpoints with errors		Selected: only testpoints are shown that violate DRC for testpoint values. Not selected: all testpoints are shown.
Update		If testpoint data is changed while the Testpoints dialog is open, the data that is shown in the dialog is updated.
Testpoints table
	Testpoint reference	The reference name that is automatically assigned to the testpoint.
	Net name	The net that is associated with the testpoint.
	Component pin	The component pin that is associated with the testpoint.
	Component placed area	For the component that is associated with a testpoint, this is the side of the board on which it is placed.
	Padstack name	The name of the padstack.
	Padstack angle	The angle that is associated with a padstack.
	Padstack type	Indicates the type of padstack as SMD (Surface Mount Device) or PTH (Plated Through Hole) or VIA.
	Testpoint side	The side of the board on which the testpoint is placed.
	X coordinate	The X coordinate for the position of the testpoint.
	Y coordinate	The Y coordinate for the position of the testpoint.
	On grid	Indicates whether the testpoint is located on the lines of the grid.
	Error status	Shows the error status of the testpoint, if applicable. An error is shown if the testpoint violates a DRC for testpoint value.
Report		Displays the Testpoint Position Report dialog.