Slot Hole
Use the Slot Hole
command to create a slot hole in the board in Footprint Editor.
This command is only available in 2D
View mode.
Command Dialog
Hole diameter
| Value |
Description |
| Real number greater than 0. |
Set the diameter of the slot hole that is added. This must
be smaller than or equal to Length. |
Length
| Value |
Description |
| Real number greater than 0. |
Set the length of the slot hole that is added. This must be
greater than or equal to Hole diameter. |
Angle
| Value |
Description |
| Real number greater than -360 and smaller than 360. |
Set the angle of the hole that is added. |
